Setup

This monitor works with platforms running at horizontal frequencies between 30 and 121 kHz.

Step 1: Connect your monitor to your computer

With the monitor and computer switched off, connect the video signal cable to the video input connector of the monitor and to the video output of the computer.

To a computer

with an HD15 forward side video output

rear side

AC IN

(HD15)

(HD15)

1

2

forward side

rear side

To a computer with an

HD15 video output

Notes

•Do not touch the pins of the video signal cable connector as this might bend the pins.

•When connecting the video signal cable, check the alignment of the HD15 connector. Do not force the connector in the wrong way or the pins might bend.

Step 2: Connect the power cord

With the monitor and computer switched off, first connect the proper power cord for your local power supply to the monitor, then connect it to a power outlet.

AC IN

(HD15)

(HD15)

1

2

to AC IN

to a power outlet

power cord

Step 3: Turn on the monitor and computer

First turn on the monitor, then turn on the computer.The installation of your monitor is complete.If necessary, use the monitor’s controls to adjust the picture.If no picture appears on your screen•Check that the monitor is correctly connected to the computer.

•If NO INPUT SIGNAL appears on the screen, follow the on- screen messages (page 15).

•If you are replacing an old monitor with this model and OUT OF SCAN RANGE appears on the screen, reconnect the old monitor. Then adjust the computer’s graphic board so that the horizontal frequency is between 30 – 121 kHz, and the vertical frequency is between 48 – 160 Hz.

For more information about the on-screen messages, see “Trouble symptoms and remedies” on page 16.

6