Sony CPD-200ES, CPD-200EST, CPD-100ES, CPD-100EST Entering New Timings, Power Saving Function

Entering New Timings

When using a video mode that is not one of the factory preset modes, some fine tuning may be required to optimize the display to your preferences. Simply adjust the monitor according to the preceding adjustment instructions. The adjustments will be stored automatically and recalled whenever that mode is used.

Power Saving Function

This monitor meets the power saving guidelines set by the International ENERGY STAR Program as well as the more stringent NUTEK guidelines. It is capable of reduced power consumption when used with a computer equipped with Display Power Management Signaling (DPMS). By sensing the absence of the sync signal coming from the computer, it will reduce the power consumption as follows:

CAUTION: The Power Saving function will automatically put the monitor into Active-off state if the power switch is turned on without any video signal input. Once the horizontal and vertical syncs are sensed, the monitor will automatically return to its Normal operation state.

	State	Power	Recovery	u POWER
		consumption	time	indicator
	Normal	110 W
1		(100ES/100EST)	––	green on
	operation	120 W
		(200ES/200EST)
	Standby		approx.	Orange and
2	(1st step of	15 W		green flashes
			3 sec.
	power saving)			alternately
3	Suspend	15 W	approx.	Orange and
	(2nd step of		3 sec.	green flashes
	power saving)			alternately
	Active-off		approx.	Orange on
4	(3rd step of	8 W
			10 sec.
	power saving)
5	Power-off	≈ 0 W	––	off

Plug and Play

This monitor complies with DDCTM1 and DDC2B, which are the Display Data Channel (DDC) standards of VESA. When a DDC1 host system is connected, the monitor synchronizes with the V. CLK in accordance with the VESA standards and outputs the EDID (Extended Display Identification Data) to the data line.

When a DDC2B host system is connected, the monitor automatically switches to the DDC2B communication.

DDCTM is a trademark of the Video Electronics Standard Association.

Use of the Tilt-Swivel

With the tilt-swivel, this unit can be adjusted to be viewed at your desired angle within 180˚ horizontally and 20˚ vertically. To turn the unit vertically and horizontally, hold it at its bottom with both hands.

15°

90°

90°

5°

Damper Wire

Using a white background, very thin horizontal stripes on the screen are visible as shown on the illustration. These stripes are damper wires. These wires are attached to the aperture grille inside the Trinitron tube and are there to dampen vibrations of the aperture grille in order to prevent them from influencing the picture quality.

Damper wire

Approx. 6 cm (CPD-200ES/ 200EST only)

Approx. 6 cm

8