Customizing Your Monitor
Automatically Adjusting the PictureIf the picture is flickering or fuzzy, press the AUTO button. The monitor is automatically adjusted to match the signal from the connected computer.
Further fine adjustments may be needed with some computers. In this case, manually adjust the monitor.
1Turn on the monitor.
2Turn on the computer.
3Press the AUTO button.
Themonitoradjuststhepitchtomatchtheinputsignal sothatthepictureappearssharp,andfitsthepictureto thecenterofthescreen.
AUTO
Notes
•This function is intended for use with a computer running Windows or similar graphic user interface software that provides a
•The screen may go blank for a few seconds while performing the
If the picture is flickering or fuzzy even after you press the AUTO button
Adjust the Pitch and Phase by referring to “Eliminating Flickering or Blurring Manually.”
If the picture is not in the center of the screen even after you press the AUTO button
Adjust using the CENTER OSD by referring to “Adjusting the Picture Position.”
If a part of the screen is flickering or blurring, press the AUTO button. If this operation does not work, adjust the Pitch and Phase as follows.
Once the pitch and phase are adjusted, they will be stored in memory for the current input signal.
1Set the resolution to 1280 ⋅ 1024 on the computer.
Iftheresolutionofthegraphicsboardislowerthan1280 ⋅1024,setZOOMtoREAL(page12).
2Load the Utility Disk.
Usetheappropriatediskforyourcomputer.
For Windows 95/98
WindowsMonitorInformationDisk/UtilityDisk
For Macintosh
MacintoshUtilityDisk
3Start the Utility Disk and display the test pattern. For Windows 95/98
Click[UtilityDisk] n[Windows] n[Utility.exe].
For Macintosh
Click[UtilityDisk]
4Press the MENU button.
TheMENUOSDappears.
MENU OK
MENU
MENU
EXIT
PHASE
PITCH
CENTER
ZOOM/SMOOTHING
COLOR
LANGUAGE
OPTION
5Press the ˘/³buttons to select PITCH, and press the
MENU button again.
ThePITCHOSDappears.
MENUPITCH
0
10