Set up

Preparing the Cyber-shot Station

Connect the AC adaptor to the DC IN jack of the Cyber-shot Station.

Cyber-shot Station

DC plug

AC adaptor

To a wall outlet

 

 

 

 

(wall socket)

 

 

 

AC Power cord (mains lead)

Do not use the AC adaptor placed in a narrow space, such as between a wall and furniture.

To use your Cyber-shot Station abroad - Power sources

You can use the Cyber-shot Station and the AC adaptor (supplied) in any country or region where the power supply is within 100 V to 240 V AC, 50/60 Hz.

Use a commercially available AC plug adaptor, if neccessary, depending on the design of the wall outlet (wall socket).

AC plug adaptor

Do not use an electronic transformer (travel converter), as this may cause a malfunction.

Preparing the remote control

Notes on the remote control

•The remote control is powered by a button type lithium battery (CR2025) installed at the factory. To avoid draining the battery, an insulation sheet is inserted. Before using the remote control for the first time, remove the insulation sheet.

•Point the remote sensor of the Cyber-shot Station away from strong light sources such as direct sunlight or overhead lighting. Otherwise, the remote control may not function properly.

•The remote control range is less than five meters (for indoor use). Point the remote control at the remote sensor of the Cyber- shot Station. Try adjusting the angle of the remote control if you cannot operate the Cyber-shot Station.

Removing the insulation sheet

Insulation sheet

Placing the camera on

the Cyber-shot Station

–Insert the “Memory Stick” into your camera.

–Be sure to turn off the camera before placing it on the Cyber-shot Station or removing it from the Cyber-shot Station.

–Be sure the camera is securely attatched to the Cyber-shot Station.

8-GB