Preparing the remote control

Notes on the remote control

•The remote control is powered by a button type lithium battery (CR2025) installed at the factory. An insulation sheet is inserted to avoid the battery exhaustion. Remove the insulation sheet before using the remote control for the first time.

Insulation sheet

Placing the camera on

the Cyber-shot Station

Attach the camera, as refering to the image below.

•Point the remote sensor of the Cyber-shot Station away from strong light sources such as direct sunlight or overhead lightings. Otherwise, the remote control may not function properly.

•The remote control range is less than five meters (for indoor use). Point the remote control at the remote sensor of the Cyber- shot Station. Try adjusting the angle of the remote control if you cannot operate the Cyber-shot Station.

–Insert the “Memory Stick Duo” into the camera. When you use data in the internal memory, do not insert the “Memory Stick Duo” into the camera.

–Be sure to turn off the camera before placing it on or removing it from the Cyber-shot Station.

–Make sure that the camera is securely attached to the Cyber-shot Station.

Removing the camera from the Cyber-shot Station

–Hold the Cyber-shot Station down when you remove the camera from the Cyber-shot Station.

10-GB