
PROGRAMMED EDIT
RECORDING
5
Q
3,7*J”-I ~
Programmed edit function enables CD recording while checking the remaining time on each side of the tape as the tracks are programmed.
The programmed edit recording will not start from a point halfway in the tape, The tape must be recorded from the beginning of either side.
1 Insert the tape into deck 2, and press the DOLBY NR button to turn Dolby NR on or off.
Insert the tape with the side to be recorded on first facing out from the unit.
2 Press the CD button and load the disc(s).
3 Press the CD EDIT/CHECK button twice
“EDIT and “PRGM” light up on the display.
PRGEOm
When “Al” is displayed, press the CD EDIT/CHECK button again.
4 Press the +4 or > button to designate the tape length.
10 to 99 minutes can be specified,
| Maximum | recording |
Tape length | time for | side A |
Tape side A (front side)
5 Press the DISC DIRECT PLAY button, then press one of the numbered buttons 1 to 3 within 3 seconds on the remote control.
Then, press the numbered buttons and the + 10 button on the remote control to program a track.
Example: To select the 10th track of disc 2, press the DISC DIRECT PLAY and 2 buttons, then press the + 10 and O buttons.
6 Repeat step 5 for the rest of the tracks for side A.
A track whose playing time is longer than the remaining time cannot be programmed.
Remaining time of side A
Total number Programmed
of programmed tracks tracks
7 Press the CD EDIT/CHECK button to select side B and program the tracks for side B.
After confirming Bon the display, repeat step 5,
Tape side B (reverse side)
8 Press the O REC/REC MUTE button to start recording.
The tape is rewound to the beginning of the front sidle, the lead segment is played through for 10 seconds, and recording starts. When recording on the front side (A) ends, recording on the back side (B) starts.
To stop recording
Press the ■ button. Recording and CD play stop simultaneously,
To check the order of the programmed track numbers
Before recording, press the CD EDIT/CHECK button to select
side A or B, and press the < or - button repeatedly,
Program number
Track number Programmed track numbers
To change the program of each side
Press the CD EDIT/CHECK button to select side A or E3, and press the ■ CLEAR button to clear the program of the selected side. Then program tracks again.
To clear the edit program
Press the ■ button twice so that “EDIT” disappears on the display.
Recording is inhibited if the erasure prevention tab on either sicle of the tape is broken off.