Sony CX-NMT90 manual Play with Dolby PRO Logic, Additional Dolby PRO Logic Modes

PLAY WITH DOLBY PRO LOGIC

DOLBY

PRO LOGIC -—.

LF -a

DOLBY

PRO LOGIC

1 Press the VIDEO/AUX button and start playback of the video source.

2 Press the DOLBY PRO LOGIC button.

NORMAL is selected, and the playback sound has the DOLBY PRO LOGIC effect.

To cancel Dolby Pro Logic mode

Press the DOLBY PRO LOGIC button repeatedly until P-OFF is displayed.

To change the sound levels during playback

After adjusting the balance with the noise sequencer, the sound levels of the center or surround speakers can be adjusted during playback of laser discs or video software,

1 Press the MANUAL SELECT (TEST) button on the remote

control repeatedly to select “CEN” (center) or ‘(SUR” (surround).

2While the “CEN” or “SUR” is displayed, press the DOWN 1<< or UP Ebl button on the remote control to adjust the volume.

ADDITIONAL DOLBY PRO LOGIC MODES

[n addition to the NORMAL mode, this unit is also equipped with

the PHANTOM and the 3 CH LOGIC modes.

PHANTOM mode: Use this mode when no center speaker is

connected. The center channel signals are output through the left and right speakers.

3 CH LOGIC mode: Use this mode when no surround speakers are connected. This mode reproduces rear sounds through the front speakers.

To select PHANTOM or 3 CH LOGIC

Press the DOLBY PRO LOGIC button repeatedly until the desired Dolby Pro Logic mode is displayed. The Dolby Pro Logic mode is displayed cyclically as follows.

~ NORMAL - PHANTOM+ 3 CH LOGIC 1

To adjust the balance of connected speaker sound levels Carry out steps 2 to 4 on page 17.

EXE!

●Depending on the sound source and/or listening conditions, a surround effect may not be obtained even when the DOLBY PRO LOGIC is on.

●The full DOLBY PRO LOGIC effect cannot be obtained when using software without IX IDOLHYSURROUNDImark. In this case, use the SURROUND system instead. (See page 7.)

ENGLISH 18