Sony DAV-C450 manual 24GB, Setup for the system for Asian and Australian models

OUT	I N	I N
	L	L			S V I D E O
AM					(DVD ONLY)
	R	R O P T I C A L			V I D E O
COAXIAL		D I G I T A L
		I N
AUDIO 1		AUDIO 2		MONITOR OUT
FM		FRONT	R	CENTER	FRONT	L
75Ω
		REAR	R	WOOFER	REAR	L

S P E A K E R

Y P B / C B P R / C R

COMPONENT VIDEO OUT

IN OUT

AUDIO AUDIO

IN OUT

L

R

OUT OUT

AUDIO

OUT

LOUTPUT

R

OPTICAL

IN

INPUT

VIDEO

IN

IN

COMPOMENT

VIDEO IN

Y

P B / B - Y

P R / R - Y

VCR	Digital satellite receiver	TV monitor	Equipment with component
			video input jacks

If you connect a digital satellite receiver with the OPTICAL jack

The digital satellite receiver can be connected to the OPTICAL jack instead of the AUDIO IN L/R jacks of the system.

The system can accept both digital and analog signals. Digital signals have priority over analog signals. If the digital signal ceases, the analog signal will be processed after 2 seconds.

If you connect a digital satellite receiver without the OPTICAL jack

Connect the digital satellite receiver to the AUDIO IN L/R jacks of the system.

Setup for the system (for Asian and Australian models)

Setup is necessary for the system, depending on the TV monitor to be connected. The initial setting for Asian models is NTSC but the Australian model is PAL.

If the color system of the TV is PAL*

To set the system to PAL, turn on the system by pressing 1 on the remote while pressing X on the system. You need to hold X until DAV-C450 appears on the display. To reset to NTSC, turn off the system and then turn on again using the remote while pressing X on the system.

*If the color system of the TV is NTSC, do the same operation above to set the system to NTSC.

Connecting the AC Power Cord

Before connecting the AC power cord of this system to a wall outlet, connect the speakers to the system (see page 18).

Connect the AC power cord of your TV/video components to a wall outlet.

24GB