x[AUDIO DRC] (DVD VIDEO only)

Narrows the dynamic range of the sound track. Useful for watching movies at low volume late at night.

[OFF]

No compression of dynamic

 

range.

 

 

[STANDARD]

Reproduces the sound track with

 

the kind of dynamic range that the

 

recording engineer intended.

 

 

[MAX]

Compresses dynamic range fully.

 

 

x[AUDIO (HDMI)]

Selects the type of audio signal output from the HDMI OUT jack.

[OFF]

The sound is not output from the

 

HDMI OUT jack.

 

 

[AUTO]

Outputs audio signals that is

 

matched to the requested audio

 

stream from the connected TV.

 

 

[PCM]

Converts Dolby Digital, DTS

 

(digital theater system), or 96

 

kHz/24 bit PCM (pulse code

 

modulation) signals to 48 kHz/ 16

 

bit PCM (pulse code modulation).

 

 

Note

•A loud noise (or no sound) will be output if you connect the system to a TV that is not compatible with DOLBY DIGITAL/DTS (digital theater system) signals and [AUTO] is selected. In this case, select [PCM].

•When you connect the system and TV with the HDMI cable and [AUTO] or [PCM] is selected, AUDIO DRC, A/V SYNC, TONE, MOVIE/MUSIC, and sound field are not applied to the sound that is output from the TV.

Returning to the Default Settings

Returning the settings on the Setup Display to the default1 Select [RESET] in Step 4 of “Using the Setup Display” (page 78) and press .2 Select [YES] using X/x.

You can also quit the process and return to the Control Menu by selecting [NO] here.

3 Press .

All the settings explained on pages 79 to 83 return to the default settings. Do not press [/1 while resetting the system as it takes a few seconds to complete.

Note

•When you turn the system on after resetting and no disc is in the unit, the guide message appears on the TV screen. To perform the Quick Setup (page 18), press , to return to normal screen, press CLEAR.

•“BASS,” “TREBLE,” (page 33) and “SW LEVEL” (page 77) settings are also returned to the default.

Returning the sound field settings or radio settings to the default1 Turn off the power.2 Press and hold "/1 on the unit about 5 seconds.

“MEMORY CLR” and “PUSH POWER” appear alternately in the front panel display about 10 seconds.

3 Press "/1.

“CLEARING” appears in the front panel display and the default settings are returned. After “CLEARED!” appears, the system is turned off.

Note

•In Step 3, if you do not press "/1 or press any buttons other than "/1 on the unit, the system turns on. The setting is not made.

Adjustments and Settings Advanced

83US