STANDARD SET (continued)
DATE/TIME
Date Time
•appears for an image recorded using a flash.
•The data code is displayed on the TV screen if you connect your camcorder to a TV.
•The indicator toggles through the following
sequences as you press DATA CODE on the remote commander: DATE/TIME CAMERA DATA OFF (no indication) (Except for
•Depending on the disc condition, Bars
•The setting returns to [OFF] when you have the power source disconnected from your camcorder for more than 5 minutes.
DISC REMAINAUTO
Displays the remaining disc indicator for about 8 seconds in situations such as those described below.
•When you check the disc remaining by sliding the POWER switch down to
(Movie) or | (Still). |
•When you set the POWER to (Movie)
or (Still), then press the DISP/BATT INFO to switch the indicator off to on.
•When the remaining capacity of the disc is
less than 5 minutes for (Movie) or 30
images for | (Still). |
•When you start recording from the line input.
ON
Always displays the remaining disc indicator.
REMOTE CTRL (Remote control) (Except for
The default setting is [ON] so that you can use the Remote Commander (p. 41).
•Set to [OFF] to prevent your camcorder from responding to a command sent by other equipment’ remote control.
•The setting returns to [ON] when you have the power source disconnected from your camcorder for more than 5 minutes.
REC LAMP (Recording lamp)The camera recording lamp will not light up during recording when you set this to [OFF]. (The default setting is [ON].)
BEEPON
A melody sounds when you start/stop recording, or operate the touch panel.
OFF
Cancels the melody.
DISP OUTPUTLCD PANEL
Shows displays such as the counter on the LCD screen and in the viewfinder.
Shows the display also on the TV screen.
SETUP ROTATENORMAL
Scrolls the setup items downwards by touching .
OPPOSITE
Scrolls the setup items upwards by touching .
68