On the pickup lens

Do not touch the lens inside the disc cover. Keep the disc cover closed except when inserting and removing the disc, to keep dust out.

When the camcorder does not work because the pickup lens is dirty, clean it with a blower (not supplied). Do not touch the pickup lens directly during cleaning because this may cause the camcorder to malfunction.

pickup lens

Care and storage of the camera lens

Wipe the surface of the lens clean with a soft cloth in the following instances:

when there are fingerprints on the lens surface.

in hot or humid locations

when the lens is exposed to salty air such as at the seaside.

Store the lens in a well-ventilated location subject to little dirt or dust.

To prevent mold, periodically clean the lens as described above. It is recommended that you operate your camcorder about once a month to keep it in optimum state for a long time.

To charge the pre-installed rechargeable battery

Your camcorder has a pre-installed rechargeable battery to retain the date, time, and other settings even when the POWER switch is set to OFF (CHG). The pre-installed rechargeable battery is always charged while you are using your camcorder but it will get discharged gradually if you do not use your camcorder. The rechargeable battery will be fully discharged in about 3 months if you do not use your camcorder at all. However, even if the pre-installed rechargeable battery is not charged, the camcorder operation will not be affected as long as you are not recording the date.

Procedures

Connect your camcorder to a wall outlet using the AC adaptor supplied with your camcorder, and leave your camcorder with the POWER switch turned off for more than 24 hours.

To change the battery of the Remote Commander (Except for DCR-DVD92/ DVD602)

While pressing on the tab, inset your fingernail into the slit to pull out the battery case.

Place a new battery with the + side facing up.

Insert the battery case back into the Remote Commander until it clicks.

Tab

Information Additional

111