
This is not a malfunction. Do not close the cassette lid until the cassette is ejected.
Note on moisture condensation
Moisture may condense when you bring your camcorder from a cold place into a warm place (or vice versa) or when you use your camcorder in a humid place as shown below.
•When you bring your camcorder from a ski slope into a place warmed up by a heating device.
•When you bring your camcorder from an air- conditioned car or room into a hot place outside.
•When you use your camcorder after a squall or a shower.
•When you use your camcorder in a hot and humid place.
How to prevent moisture condensation
When you bring your camcorder from a cold place into a warm place, put your camcorder in a plastic bag and seal it tightly. Remove the bag when the air temperature inside the plastic bag has reached the surrounding temperature (after about one hour).
Video head
•When the video head becomes dirty, you cannot record pictures normally, or distorted picture or sound is played back.
•The video head suffers from wear after long use. If you cannot obtain a clear image even after using a cleaning cassette, it might be because the video head is worn. Please contact your Sony dealer or local authorized Sony service facility to have the video head replaced.
•If the following problem occurs, clean the video heads for 10 seconds with the Sony
When you play back in the Digital8 system
–
–Playback pictures do not move.
–Playback pictures do not appear or the sound breaks off.
–[x Dirty video head. Use a cleaning
cassette.] appears on the screen during recording.
When you play back in the Hi8 /standard
8 mm system
–[x Dirty video head. Use a cleaning cassette.] appears on the screen during recording.
–Playback pictures contain noise.
–Playback pictures are hardly visible.
–Playback pictures do not appear.
LCD screen
•Do not add excessive pressure on the LCD screen, as it may cause damage.
•If your camcorder is used in a cold place, a residual image may appear on the LCD screen. This is not a malfunction.
•While using your camcorder, the back of the LCD screen may heat up. This is not a malfunction.
To clean the LCD screen |
| |
Additional | ||
LCD Cleaning Kit (optional), do not apply the | ||
• If fingerprints or dust make the LCD screen |
| |
dirty, it is recommended you use the cleaning |
| |
cloth (supplied) to clean it. When you use the | Information | |
cleaning liquid directly to the LCD screen. | ||
| ||
Use cleaning paper moistened with the liquid. |
| |
On adjustment of the LCD screen |
| |
(CALIBRATION) |
| |
The buttons on the touch panel may not work |
| |
correctly. If this happens, follow the procedure |
| |
below. It is recommended you connect your |
| |
camcorder to the wall socket using the supplied |
| |
AC Adaptor during the operation. |
|
1Slide the POWER switch up to (CHG) OFF.
2Eject the cassette and “Memory Stick” from your camcorder, then disconnect any connecting cables except the AC Adaptor from your camcorder.
,continued
Additional Information 121