3Slide the POWER switch repeatedly to select the PLAY/EDIT mode while pressing DSPL/BATT INFO on your camcorder, then press and hold DSPL/ BATT INFO for about 5 seconds.

4Touch the “×” displayed on the screen with an object such as the corner of a “Memory Stick.”

The position of the “×” changes.

CALIBRATION

If you did not press the right spot, start from step 4 again.

bNote

•You cannot calibrate the LCD screen if you have rotated the LCD panel and set it with the LCD screen facing out.

On handling the casing

•If the casing is soiled, clean the camcorder body with a soft cloth lightly moistened with water, and then wipe the casing with a dry soft cloth.

•Avoid the following to avoid damage to the finish.

–Using chemicals such as thinner, benzine, alcohol, chemical cloths, repellent and insecticide.

–Handling with above substances on your hands.

–Leaving the casing in contact with rubber or vinyl objects for a long period of time.

About care and storage of the lens

•Wipe the surface of the lens clean with a soft cloth in the following instances:

–When there are fingerprints on the lens surface.

–In hot or humid locations

–When the lens is exposed to salty air such as at the seaside.

•Store in a well-ventilated location subject to little dirt or dust.

• To prevent molds periodically clean the lens as described above.

It is recommended you operate your camcorder about once a month to keep it in an optimum state for a long time.

To charge the pre-installed button-type battery

Your camcorder has a pre-installed button-type battery to retain the date, time, and other settings even when the POWER switch is set to (CHG) OFF. The pre-installed button-type battery is always charged while you are using your camcorder but it will get discharged gradually if you do not use your camcorder. The button-type battery will be fully discharged in about 3 months if you do not use your camcorder at all. However, even if the pre- installed button-type battery is not charged, the camcorder operation will not be affected as long as you are not recording the date.

Procedures

Connect your camcorder to a wall socket using the supplied AC Adaptor, and leave it with the POWER switch set to (CHG) OFF for more than 24 hours.

122Additional Information