Enable printer to connect

[USB Connect] is set to [PictBridge], however the camera is connected to a non-PictBridge compliant device.

Check the device.

The connection is not established. Disconnect and connect the USB cable again. If an error message is indicated on the printer, refer to the operating instructions supplied with the printer.

Connect to device

You tried to print images before the printer connection was established. Connect to a PictBridge compliant printer.

No printable image

You tried to execute [DPOF image] without placing a DPOF (Print order) mark on the image(s).

You tried to execute [All In This Folder] while a folder that holds only movies was selected. You cannot print movies.

Printer busyPaper errorNo paperInk errorLow InkNo Ink

Check the printer.

Printer error

Check the printer.

Check if the image you want to print is corrupted.

The data transmission to the printer may not be completed yet. Do not disconnect the USB cable.

Processing

The printer is canceling the current print job. You cannot print until it is finished. This may take time, depending on the printer.

Recover data

The data in Album has been destroyed. Recover the data by selecting [OK]. When you want to start recording immediately, select [Cancel] to start your operation. However, each time you turn on the camera, the same error massage appears until you recover the data.

When you start recovering the data, the protection of images is canceled. If you want the images to be protected, protect the images again (page 46).

Even when the power source is cut off during formatting the album, the format will be completed. The error occures and it can be fixed, yet the data can not be recovered.

96