Audio dubbing

To play back the new recorded sound

Adjust the balance between the original sound (ST1) and the new sound (ST2) by selecting AUDIO MIX in the menu system.

 

V T R S E T

 

 

 

 

 

 

 

H i F i

S O U N D

 

 

 

 

 

 

 

A U D I O

M I X

 

 

 

 

 

 

 

R E T U R N

ST1

 

ST2

[ M E N U ] : E N D

(Illustration: DSR-PD100A)

Five minutes after when you disconnect the power source or remove the battery pack, the setting of AUDIO MIX returns to the original sound (ST1) only. The factory setting is original sound only.

If you make all the connections

The audio input to be recorded will take precedence over others in the following order. •MIC (PLUG IN POWER) jack

•Intelligent accessory shoe •AUDIO/VIDEO jack •Built-in microphone

If an i.LINK cable (DV connecting cable) is connected to this unit

You cannot add a sound to a recorded tape.

If you disconnect or connect a cable to the camcorder during recording

The recording may stop.

Notes on audio dubbing

•A new sound cannot be recorded on a tape already recorded in the FS48K (16-bit) mode (32 kHz, 44.1 kHz or 48 kHz).

•When an external microphone is not connected, the recording will be made through the built-in microphone of the camcorder.

•If you add a new sound on a tape recorded with another camcorder (including DSR- PD100A/PD100AP), the sound quality may become worse.

•You cannot add audio with the DV IN/OUT jack.

operations Advanced

89