Sony DTC-A6 operating instructions Basic Operations, To record from the beginning of the tape

zIf “UNLOCK” appears in the display

The program source is not connected to the deck properly or is not turned on. Make sure that the program source is properly connected or turned on.

Basic Operations

5 Locate the position where you want to start recording.

To record from the beginning of the tape

Press REW 0 to rewind the tape to its beginning.

To record from the end of the recorded portion

1Press REW 0 to rewind the tape to its beginning.

2Press FF ).

The deck locates the end of the recorded portion on the tape and stops automatically.

6	Press REC r.
	The deck becomes ready to record.
7	When recording the analog input signal, adjust the recording
	level with REC LEVEL.
	The recommended recording level is 3. For details, refer to
	“Adjusting the Recording Level for Analog Recording” on
	page 9.
8	Press PAUSE P or PLAY (.
	Recording starts.
9	Start playing the program source.
	When the tape reaches the end, the deck rewinds it
	automatically to its beginning and stops (Auto Rewind).
To		Press
Stop recording		STOP p
Pause recording		PAUSE P. Press the button again to
		resume recording.
Take out the cassette		OPEN/CLOSE ¤ after stopping
		recording

To prevent accidental erasure

Slide the record-protect tab to the left as shown in the illustration below.

Recording is impossible (the hole is open).

Recording is possible (the hole is closed).

Basic Operations

7EN

3-856-761-11(2)