◆VIRTUAL MULTI REAR
Creates an array of virtual rear speakers from a single set of actual rear speakers.
The position of the virtual rear speakers differs according to “REAR” or “SIDE” setting of the rear speakers (page 81).
REAR
LR
L:Front speaker (left)
R:Front speaker (right) LS: Rear speaker (left) RS: Rear speaker (right) 
: Virtual speaker
zHints
•You can select “SURROUND” by pressing the SURROUND button on the player.
•You can also select “SURROUND” from the Control Menu (page 13).
LSRS
SIDE
LR
LS | RS |
◆VIRTUAL MULTI DIMENSION
Creates an array of virtual rear speaker positions higher than the listener from a single set of actual rear speakers.
This mode creates five sets of virtual speakers
surrounding the listener at approximately a 30° angle of elevation. The effect differs
according to “REAR” or “SIDE” setting of the rear speakers (page 81).
REAR
LR
SIDE | LS | RS | |
L | R | ||
| |||
| LS | RS |
Notes
•To enjoy the multichannel audio through the 5.1CH OUTPUT jacks, correctly set each speaker position and distance (page 81).
•When the playing signal does not contain a signal for the rear speakers, it may be difficult to hear the sound effects.
•When you select one of the TVS modes, the player does not output the sound of centre speaker.
•When you select one of the surround modes, turn off the surround setting of the connected TV or amplifier (receiver).
•Make sure that your listening position is between and at an equal distance from your speakers, and that the speakers are located in similar surroundings.
•“TVS NIGHT” only works with Dolby Digital discs. However, not all discs will respond to the “TVS NIGHT” function in the same way.
•If you use the DIGITAL OUT (OPTICAL or COAXIAL) jack and set “DOLBY DIGITAL” to “DOLBY DIGITAL,” “DTS” to “DTS” (for
•If the player is set up to output the signal from the DIGITAL OUT (OPTICAL or COAXIAL) jack, the TVS effect will not be heard when you play a CD.
60