Sony GC75 Install the software, Create a dial-upconnection

Installation

Your GC75 comes in two pieces, the data card, which you insert into the laptop, and a detachable antenna.

2.Connect the antenna to the end of the GC75 next to the SIM Card tray.

Install the software

1.Insert the GC75 CD into your laptop’s CD drive. If the CD does not start automatically, select Start Run and type D:/setup.exe in to the Run dialog box. (Where D is your CD drive.)

2.The Choose Setup Language dialog opens. Select your required language from the drop down list. Click OK.

3.The InstallShield Wizard for the GC75 Manager opens. Follow the on screen instructions. When installation is complete click Finish.

4.Fully insert the GC75 Data Card into your laptop PC. A beep signals that your laptop has recognised it.

5.After a few seconds the New Hardware dialog opens and the necessary drivers for the GC75 are installed from the GC75 CD.

6.The GC75 and the GC75 Manager software are now installed and ready for use. Select Programs Sony Ericsson

GC75 Manager to open the GC75 Manager.

7.Enter your SIM Card PIN, if requested. Click OK.

8.GC75 Manager opens. After a short delay your signal strength and network operator are displayed in the Status screen.

Create a dial-up connection

1.From GC75 Manager select .

2.Check the box next to Create a new dial- up connection, enter a name for the new connection, for example ‘My Connection’, and click Next.

3.Select the type of data connection you require. Choose from:

•GPRS (General Packet Radio Service)

•CSD/HSCSD (Circuit Switch Data/High Speed Circuit Switch Data)

4.Select your Network Operator from the drop down list at the bottom of the screen. If your Network Operator is not listed select <Other>. Click Next.

Note:

The correct parameters for connection to the Network Operator you select from the list are automatically entered for you.

12