Sony DAV-HDX265, HDX265, HDX266, HDX267W 69GB, continued, xThe measurement is OK, x The measurement is not OK, Adjustments and Settings Advanced, 5 Press X/x to select [YES], then press, retry

Connect the calibration mic to the A.CAL MIC jack on the front panel, and set it up at the ear level using a tripod, etc. (not supplied). The front of each speaker should face the calibration mic, and there should be no obstruction between the speakers and the calibration mic. Be quiet during the measurement.

AUDIO IN / A.CAL MIC

Calibration mic

Note

•Avoid being in the measurement area and making noise during the measurement (about three minutes), to avoid measurement failure. During the measurement, test signals are output from the speakers.

•The environment of the room in which the system is installed may affect measurements.

•If an error message appears, follow the message, then select [YES].

An error message appears when:

–the headphones are connected.

–the calibration mic is not connected.

–front speakers are not correctly connected.

–surround speakers are not correctly connected.

–front and surround speakers are not correctly connected.

–there is excessive noise around the calibration mic.

–the calibration mic is overloaded.

6 Press C/X/x/c to select [YES] or [NO], then press.xThe measurement is OK.Disconnect the calibration mic, then select [YES]. The result is implemented.

Measurement complete.

FRONT L :	YES
FRONT R :	YES
CENTER :	NONE
SUBWOOFER :	YES
SURROUND L :	NONE
SURROUND R :	NONE

If OK, unplug calibration mic and select

“YES”. YES NO

Adjustments and Settings Advanced

5 Press X/x to select [YES], then press			x The measurement is not OK.
			Follow the message, then select [YES] to
.			retry.
Calibration starts.
				Measurement failure.
	Measuring. Please wait a moment.			Check speaker connection.
				Retry?
					YES
					NO
		Tip
		• You can check the distance between the listening
		position and each speaker. See page 76.
						continued

69GB