When you select “WARN CHK”

If a warning on the measurement result is present, detailed information is displayed.

Press to return to step 2 of “Confirming/saving the measurement results”.Warning code Explanation
WARN 40The Auto Calibration has

 

completed. However, the noise

 

level is high. You may be able to

 

perform the Auto Calibration

 

properly if you try it again, even

 

though the measurement cannot

 

be performed in all environments.

 

Try to perform the Auto

 

Calibration in a quiet

 

environment.

 

 

WARN 41

The sound input from the

 

optimizer microphone is out of

 

the acceptable range. It is louder

 

than the loudest sound that can be

 

measured. Try to perform the

 

Auto Calibration when the

 

environment is quiet enough to

 

allow proper measurement.

 

 

WARN 42

The volume of the receiver is out

 

of the acceptable range. Try to

 

perform the Auto Calibration

 

when the environment is quiet

 

enough to allow proper

 

measurement.

 

 

WARN 43

The distance and position of a

 

subwoofer cannot be detected.

 

This may be caused by noise. Try

 

to perform the Auto Calibration

 

in a quiet environment.

 

 

NO WARN

There is no warning information.

 

 

When you select “PHASE”

You can check the phase of each speaker (in phase/out of phase).Press V/v repeatedly to select a
speaker, then pressto return to
step 2 in “Confirming/saving the
measurement results”.

 

 

 

 

Display

Explanation

 

 

 

xx* INThe speaker is in phase.

 

 

xx* OUT

The speaker is out of phase. The

 

 

“+” and “–” terminals of the

 

 

speaker may be connected the

 

 

other way around.

 

 

* xx represent a speaker channel

 

FL

Front left

 

 

FR

Front right

 

C

Center

 

 

SL

Surround left

 

SR

Surround right

 

SW

Subwoofer

 

Tip

Depending on the position of the subwoofer, the measurement results for polarity may vary. However, there will be no problems even if you continue to use the receiver with that value.

After you have finished

Disconnect the optimizer microphone from the receiver.

Note

If you have changed the position of the speakers, it is recommended you to perform Auto Calibration again in order to enjoy the surround sound.

Started Getting

27GB