Troubleshooting (continued)
There is no sound from one of the front speakers.
•Connect a pair of headphones to the PHONES jack to verify that sound is output from the headphones (see page 18).
If only one channel is output from the headphones, the component may not be connected to the receiver correctly. Check that all the cords are fully inserted into the jacks on both the receiver and the component.
If both channels are output from the headphones, the front speaker may not be connected to the receiver correctly. Check the connection of the front speaker which is not outputting any sound.
There is no sound or only a very
•Check that the speakers and components are connected securely.
•Check that you have selected the correct component on the receiver.
•Check that the headphones are not connected.
•Press MUTING if muting function is activated.
•The Thermal Protection has been activated because the receiver is overheated (“OVERHEAT” flashes in the display). Turn off the receiver, leave the receiver for a while, then turn on the power again.
•The Over Current Protection has been activated because of low impedance or short circuit (“PROTECT” flashes in the display). Turn off the receiver, eliminate the
20 seconds.
The left and right sounds are unbalanced or reversed.
•Check that the speakers and components are connected correctly and securely.
•Adjust balance parameters in the LEVEL menu.
There is severe hum or noise.
•Check that the speakers and components are connected securely.
•Check that the connecting cords are away from a transformer or motor, and at least 3 meters away from a TV set or fluorescent light.
•Move your TV away from the audio components.
•The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol.
There is no sound from the center speaker.
•Make sure the sound field function is on (press SOUND FIELD
•Select a sound field containing the word “CINEMA” or “VIRTUAL” (see page
•Adjust the speaker level (see page 17).
•Make sure the center speaker size parameter is set to either “SMALL” or “LARGE” (see page 16).
There is no sound or only a very
•Make sure the sound field function is on (press SOUND FIELD
•Select a sound field containing the word “CINEMA” or “VIRTUAL” (see page
•Adjust the speaker level (see page 17).
•Make sure the surround speaker size parameter is set to either “SMALL” or “LARGE” (see page 16).
There is no sound from the active sub woofer.
•When you select NORM. SP., make sure the sub woofer is set to “S.W. YES” (see page 17).
•Check that “2CH ST.” is not selected (see page 20).
Radio stations cannot be tuned in.
•Check that the antennas are connected securely. Adjust the antennas and connect an external antenna if necessary.
•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use Manual tuning.
•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (see page 24).
•The sampling frequency is more than 48 kHz. Change the input player setting to 48 kHz.
The surround effect cannot be obtained.
•Make sure the sound field function is on (press SOUND FIELD
There is no picture or an unclear picture appears on the TV screen or monitor.
•Select the appropriate function on the receiver.
•Set your TV to the appropriate input mode.