Warning code

Explanation

WARN 43

The distance and position of a sub

 

woofer cannot be detected. This

 

may be caused by noise. Try to

 

perform the Auto Calibration in a

 

quiet environment.

 

 

NO WARN

There is no warning information.

 

 

When you select “PHASE”

You can check the phase of each speaker (in phase/out of phase).Press V/v repeatedly to select a
speaker, then pressto return to
step 2 in “Confirming/saving the
measurement results”.

 

 

 

 

Display

Explanation

 

 

 

xx* INThe speaker is in phase.

 

 

xx* OUT

The speaker is out of phase. The

 

 

“+” and “–” terminals of the

 

 

speaker may be connected the

 

 

other way around. However,

 

 

depending on the speakers,

 

 

“xx* OUT” appears on the

 

 

display even though the speakers

 

 

are connected properly. This is

 

 

because of the speakers’

 

 

specifications. In this case, you

 

 

can continue to use the receiver.

 

 

* xx represent a speaker channel

 

FL

Front left

 

 

FR

Front right

 

C

Center

 

 

SL

Surround left

 

SR

Surround right

 

SW

Sub woofer

 

Tip

Depending on the position of the sub woofer, the measurement results for polarity may vary. However, there will be no problems even if you continue to use the receiver with that value.

After you have finished

Disconnect the optimizer microphone from the receiver.

A. CAL menu parameters

You can use the A. CAL menu to make settings for the Auto Calibration function to suit your preference.

Select “8-A. CAL” in the amplifier menus. For details on adjusting the parameters, see “Navigating through menus” (page 34) and “Overview of the menus” (page 35).

xAUTO CAL (Auto Calibration on/ off)•A.CAL NOThe Auto Calibration function is turned off.•A.CAL YESThe Auto Calibration function start.xCAL LOAD (Calibration load)*• LOAD YESSelect this when you want to load the saved Auto Calibration result.• LOAD NOSelect this when you do not want to load the saved Auto Calibration result.

*You can select this parameter only when you have performed the Auto Calibration and saved the settings.

Started Getting

29GB