Remote

Operations

Function

Button

 

 

 

 

 

X ws

VCR/

Pauses playback or

 

CD player/

recording. (Also starts

 

DVD player/

recording with

 

MD deck/

components in

 

Tape deck

recording standby.)

 

 

 

x w;

VCR/

Stops playback.

 

CD player/

 

 

DVD player/

 

 

MD deck/

 

 

Tape deck

 

 

 

 

O wj

DVD player

Returns to the

 

 

previous menu or

 

 

exits the menu.

 

 

 

V/v wk

Receiver

Selects a menu item.

 

 

 

B/b wk

Receiver

Adjusts or changes

 

 

the setting.

 

 

 

V/v/B/b wk

VCR/

Selects a menu item.

 

Satellite tuner/

 

 

DVD player

 

 

 

 

Notes

The supplied remote can be used to control the DVD recorder if the command modes of the DVD recorder and remote’s setting are the same. The initial setting for the remote is “DVD 1”. If you cannot control the DVD recorder using the remote, you can change either the factory setting of the remote (see “Changing the factory setting of an input button” on page 34) or the command mode of the DVD recorder (refer to separate operating instructions supplied with the DVD recorder).

Some functions explained in this section may not work depending on the model.

The above explanation is intended to serve as an example only. Therefore, depending on the component the above operation may not be possible or may operate differently than described.

When you press input buttons (VIDEO 1, VIDEO 2 or DVD), the input mode of the TV might not switch to the corresponding input mode that you want. In this case, press TV/VIDEO button to switch the input mode of the TV.

To activate the buttons with orange printing, press TV and the button you want simultaneously.

.

Changing the factory setting of an input button

If the factory settings of the input buttons do not match your system components, you can change them. For example, if you have a CD player and you do not have a DVD player/DVD recorder, you can assign the DVD button to your CD player.

1 Hold down the input button whose input you want to change (for example, DVD).

2 Press the corresponding button of the component you want to assign to the input button (for example, 5 – CD player).

The following buttons are assigned to select the input:

To operate

Press

VCR (command mode VTR 3*)

1

 

 

VCR (command mode VTR 2*)

2

 

 

DVD player or

3

DVD recorder

 

(command mode DVD 1)

 

 

 

DVD recorder

4

(command mode DVD 3)

 

 

 

CD player

5

 

 

MD deck

6

 

 

Tape deck B

7

 

 

Tuner (this receiver)

8

 

 

DSS (Digital Satellite Receiver)

9

 

 

DCS (Digital CS Tuner)

0/10

 

 

BSD (Digital BS Tuner)

-/--

 

 

*Sony VCRs are operated with a VTR 2 or 3 setting. These correspond to 8 mm and VHS respectively.

Now you can use the DVD button to control the CD player.

To reset a button to its factory setting

Repeat the above procedure.

To reset all the input buttons to their factory setting

Press ?/1, TEST TONE and MASTER VOL – at the same time.

34GB