Overview 1 Chapter
Location and Function of Parts
Rear Panel
1S VIDEO jacks
2 VIDEO jacks | 7 RESET button |
3 AUDIO jacks | 8 AC IN connector |
|
4AUDIO INPUT
| LEVEL switch | 9 | HDV/DV jack |
5 | COMPONENT OUT jacks | q; LANC jack | |
6 | HDMI OUT jack | qa CONTROL S jack | |
1S VIDEO jacks
To connect a device equipped with S video jack, use S VIDEO jacks on the unit.
If you use S VIDEO jacks, you can input/output high- quality video with less signals deterioration in quality than the one connected to the standard VIDEO jack.
When DISPLAY OUTPUT switch is set to S VIDEO/ VIDEO or ALL, text data such as the time code, menus, and alarm messages are superimposed on an external monitor connected to S VIDEO jack (page 25).
For details on the output of S VIDEO jack, see “Notes on all video output jacks” (page 22).
2VIDEO jacks
Use to input and output analog video signals.
Text data is superimposed on a monitor in the same way as S VIDEO jack connection (page 25).
For details on the output of VIDEO jack, see “Notes on all video output jacks” (page 22).
3AUDIO jacks
Use to input and output analog audio signals. During normal recording, sounds are recorded onto channels 1 and 2. During audio dubbing, sounds are dubbed onto channels 3 and 4. When AUDIO OUPUT SELECT switch on the front panel of the unit is set to MIX, the audio output level becomes 50%
Notes
•In the audio dubbing mode, CH1/3 and CH2/4 jacks function as the channel 3 and channel 4 input jacks, respectively.
•To input balanced audio signals via AUDIO jacks, use a conversion cable as shown below. (The COLD side is open.)
For details on conversion cables, refer to the instruction manual of the devices you use.
GND
HOT
COLD
⋅
4AUDIO INPUT LEVEL
Note
If this switch setting is not appropriate, clipping distortion or noise may occur.
For more information on the setting of this switch, see “When you set AUDIO INPUT LEVEL switch” on page 86.
18 Chapter 1 Overview