Chapter4

Dubbing to another equipment using i.LINK jack, Duplication, Audio Dubbing, and Connecting with a Computer

Dubbing to another equipment using i.LINK jack

Computer a with Connecting and Dubbing, Audio Duplication, jack, LINK.i using equipment another to Dubbing 4 Chapter

This section describes the connections and settings necessary to perform dubbing on other equipment, using the unit as a video player.

Connections for Dubbing

Connect the unit to the recorder as shown right using an i.LINK cable.

The signal flow is automatically detected so you do not need to make separate connections for input and output. Also, connecting the unit to an editing controller via HDV/DV jack, you can configure a digital non-linear editing system.

For connections of the editing controller and the unit, refer to the editing controller instruction manual.

Before dubbing, you must set the format in which you want to output signals. Perform [HDV/DV SEL] (page

67)and [i.LINK SET] (page 69) settings in [IN/OUT REC] menu.

For details, refer to “Compatibility of HDV, DVCAM, and DV Formats” (page 93).

To dub a tape recorded in HDV format using duplicate function on such as DSR-25/45/50, select [DVCAM] in [HDV t DV CONV] of [i.LINK SET] in [IN/OUT REC] menu.

HVR-M25 (rear panel)

Monitor

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

i.LINK cable (not supplied)

i.LINK jack

Monitor

Digital video equipment with an i.LINK jack

: Signal flow

54

Chapter 4 Dubbing to another equipment using i.LINK jack, Duplication, Audio Dubbing, and Connecting with a Computer