bNotes

•The setting is not effective when you set the INPUT1 switch to LINE.

xINPUT1 TRIM

You can adjust the input signal level from INPUT1.

You can select from [-18dB], [-12dB], [-6dB], [0dB], [+6dB] and [+12dB]. The default setting is [0dB].

bNotes

•The setting is not effective when you set the INPUT1 switch to LINE.

xINPUT1 WIND

BOFF

Disables wind noise reduction.

ON

Enables wind noise reduction.

appears on the status check screen.

bNotes

•The setting is not effective when you set the INPUT1 switch to LINE.

xINPUT2 MIC NR

xINPUT2 TRIM

xINPUT2 WIND

You can set INPUT2 in the same way as INPUT1.

zTips

•-48dBu is set as 0dB in your camcorder.

•Set [INPUT TRIM] to [0dB] for the supplied microphone (ECM-XM1).

•Set [INPUT TRIM] to [+12dB] for a microphone with an average sensitivity, including the optional microphone (Sony ECM- NV1).

•The INPUT TRIM function adjusts the input level from an external microphone. When using a highly sensitive microphone or recording loud sound, set this to the minus side. When using a less sensitive microphone or recording quiet sound, set it to the plus side.

•When recording loud sound, the sound may be distorted at either the input point or the

recording point. If it is distorted at the input point, adjust the sound using the INPUT TRIM function. If it is distorted at the recording point, lower the total volume level manually.

•If you set INPUT TRIM too far to the minus side, the microphone volume becomes too low, resulting in a poor signal to noise ratio.

•Test the effect of the INPUT TRIM function according to the microphone used or the sound field of the recording site before actual recording.

AUDIO CH SEL

BCH1,CH2

Reproduces sound of CH1 and CH2 in respective channels.

CH1

Using

Reproduces sound of CH1 in channels 1

 

and 2.

the

CH2

Menu

Reproduces sound of CH2 in channels 1

 

and 2.

 

CH1+CH2

 

Reproduces mixed sound of CH1 and CH2

 

in channels 1 and 2.

 

zTips

•When you select [CH1,CH2] and play back a tape on your camcorder, sound of CH1 + CH2 comes out of the speakers.

•When you select [CH1+CH2], the same sound is outputted from right and left speakers of a device to be connected.

DV AUDIO MIX

You can monitor the sound dubbed from another device or recorded through 4- channel microphone during playback. You can set how to output the sound.

BCH1,CH2

Outputs only the sound recorded in CH1 and CH2 during recording.

MIX

Outputs mixed sound of the sound recorded in CH1 and CH2 during

Continued , 79