Getting Started

1. Installing the TV

Preventing the TV from Toppling Over

TV

Table-Top

Stand

stand

 

2

3

1

1Screw the support belt (supplied) to the TV stand with a wood screw (supplied).

2Attach the support belt to the Table-Top Stand with the securing screw (supplied) using a coin, etc.

3Adjust the length by pulling the support belt toward you while holding the Table-Top Stand.

~

•Be sure to take measures to prevent the TV from toppling over and causing injury.

•The supplied wood screw may not be used depending on the type of TV stand. In this case, or when the

securing strength is not enough, use commercial screws 1/8 to 3/16 inch (3 to 4 mm) diameter to fit to the

TV stand. Consult your dealer about the types of screw(s).

To Replace the Bezel Unit

The bezel unit can be replaced with others that are sold separately. However, do not remove the unit except to replace it. For details, see the instructions supplied with bezel units.

Preparation for Wall-Mounting

This TV can be installed on a wall by using a Wall- Mount Bracket (sold separately). Before mounting the TV on a wall, the Table-Top Stand must be removed from the TV.

Follow the simple steps below to remove the Table-Top Stand:1Disconnect all the cables from the TV.2Start removing the screws behind the TV (See illustration below).Do not remove any other screws from the TV.

3When screws are removed, lift the TV off the stand. Make sure that you carry out this task with at least two or three people. Do not attempt to lift the TV by yourself.

~

•Do not remove the Table-Top Stand for any reason other than to wall-mount the TV.

•When using an electric screwdriver, set the torque setting to approximately 2 N·m {20 Kgf·cm}.

•Be sure to store the removed screws and Table-Top Stand in a safe place until you are ready to reattach the Table-Top Stand. Keep the screws away from small children.

•For bracket installation, refer to the supplied Installing the Wall-Mount Bracket and the instruction guide provided by the Wall-Mount Bracket model for your TV. Sufficient expertise is required in installing this TV, especially to determine the strength of the wall for withstanding the TV’s weight.

•For product protection and safety reasons, Sony strongly recommends that you use the Wall-Mount Bracket model designed for your TV and that the wall-mounting of your TV is performed by a Sony dealer or licensed contractor.

10