1:Checking the accessories
Mains lead (Type BF)* (1)Coaxial cable* (1)PC cable* (1)Support belt (1) and screws (2)Stand (1) and screws (4) (only for* Do not remove the ferrite cores.
To insert batteries into the remote
Push and slide to open.
2:Attaching the stand (except for KDL- 70X3500/52X3500)
~
•Observe the correct polarity when inserting batteries.
•Do not use different types of batteries together or mix old and new batteries.
•Dispose of batteries in an environmentally friendly way. Certain regions may regulate the disposal of batteries. Please consult your local authority.
•Handle the remote with care. Do not drop or step on it, or spill liquid of any kind onto it.
•Do not place the remote in a location near a heat source, a place subject to direct sunlight, or a damp room.
To replace the bezel unit
(only for KDL-46X3000/40X3000)
The bezel unit can be replaced with others that are sold separately. However, do not remove the unit except to replace it. For details, see the instructions supplied with bezel units.
1 Place the TV onto the stand by aligning the screw hole alignment lines over the stand as shown.
2 Fix the TV to the stand using the supplied screws.
~
•This TV is very heavy, so two or more people should place the TV on the stand.
•If using an electric screwdriver, set the tightening torque at approximately 1.5 N·m (15 kgf·cm).