3 Press F/f/G/g to select the language displayed on the menu screens, then press .
4 Press F/f to select the country/region in which you will operate the TV, then press .
If the country/region which you want to use on the TV does not appear in the list, select
Auto tuning the TV
5 Before you start auto tuning the TV, insert a
The video channel will be located and stored on the TV during auto tuning.
If no VCR is connected to the TV, skip this step.
6 Press G/g to select “OK”, then press .
7 Press F/f to select “Antenna” or “Cable”, then press .
If you select “Cable”, the screen for selecting the scan type appears. See “To tune the TV for digital cable connection” on page 7.
The TV starts searching for all available digital channels, followed by all available analogue channels. This may take some time, so do not press any buttons on the TV or remote while proceeding.
If a message appears for you to confirm the aerial connection
No digital or analogue channels were found. Check all the aerial connections and press to start auto tuning again.
8 When the Programme Sorting menu appears on the screen, follow the steps of “Programme Sorting” on page 40.
If you do not wish to change the order in which the analogue channels are stored on the TV, go to next step.
9 Press MENU to exit.
The TV has now tuned in all the available channels.
~
When a digital broadcast channel cannot be received, or when selecting a country/region in which there are no digital broadcasts in step 4 (page 7), the time must be set after performing step 9.
To tune the TV for digital cable connection
1 Press F/f to select “Scan Type”, then press .
2 Press F/f to select “Quick Scan” or “Full Scan”, then press .
“Quick Scan”: Channels are tuned according to the cable provider’s information within the broadcast signal. The recommended setting for “Frequency”, “Network ID” and “Symbol Rate” is “Auto” unless your cable provider has supplied actual values to use. “Quick Scan” is recommended for fast tuning when this is supported by your cable provider.
“Full Scan”: All available channels are tuned and stored. This procedure may take some time. This option is recommended when “Quick Scan” is not supported by your cable provider.
For further information about supported cable providers, refer to the support web site:
3 Press G/g/f to select “Start”, then press
.
The TV starts searching for channels. Do not press any buttons on the TV or remote.
~
Some cable providers do not support “Quick Scan”. If no channels are detected using “Quick Scan”, perform “Full Scan”.
Guide