LCD Screen
•Although the LCD screen is made with
•Do not expose the LCD screen surface to the sun. Doing so may damage the screen surface.
•Do not push or scratch the front filter, or place objects on top of this unit. The image may be uneven or the LCD panel may be damaged.
•If this unit is used in a cold place, a smear may occur in the picture or the picture may become dark.
This does not indicate a failure. These phenomena disappear as the temperature rises.
•Ghosting may occur when still pictures are displayed continuously. It may disappear after a few moments.
•The screen and cabinet get warm when this unit is in use. This is not a malfunction.
Fluorescent lamp
This unit uses a special fluorescent lamp as its light source. If the screen image becomes dark, flickers, or does not appear, the fluorescent lamp has run down and should be replaced. For replacement, consult qualified service personnel.
Heat
Do not touch the surface of the unit. It remains hot, even after the unit has been turned off for some time.
Cleaning the screen surface
The screen surface is finished with a special coating to prevent strong light reflections. Be sure to observe the following precautions to avoid damaging the finish.
•To remove dust from the screen surface, wipe gently with a soft cloth. If dust is persistent, wipe with a soft cloth slightly moistened with a diluted mild detergent solution. You can wash and repeatedly use the soft cloth.
•Never use any type of abrasive pad, alkaline/acid cleaner, scouring powder, or strong solvent such as alcohol, benzine or thinner.
Mains lead
If you damage the mains lead, it may result in fire or electric shock.
• Do not pinch, bend, or twist the mains lead excessively. The core lines may be exposed or cut, causing a short- circuit which may induce fire or electric shock.
• Do not convert or damage the mains lead.
• Do not put anything heavy on the mains lead. Do not pull the mains lead.
•Keep the mains lead away from heat sources.
•Be sure to grasp the plug when disconnecting the mains lead. If the mains lead is damaged, stop using it and ask your dealer or Sony service centre to exchange it.
When not in use
For environmental and safety reasons, it is recommended that the unit be switched off when not in use – not left in standby mode. Disconnect it from the mains.
Cable wiring
Take care not to catch your feet on the cables. It may damage the unit.
Installation
Do not install optional components too close to the unit. Keep optional components at least 30 cm away from the unit. If a VCR is installed in front of the unit or beside the unit, the picture may become distorted.
Safety Information 17