Sony KLV 23HR2 Connecting a VCR and Cable TV, When connecting both VIDEO OUT and S VIDEO OUT, Disconnect all power sources before making any connections

Connect the CATV cable to the VCR’s IN jack.

Installing and Connecting the TV

Use this hookup if:

• You have Cable TV that does not require a cable box.

Disconnect all power sources before making any connections.

2 Using the supplied 75-ohm coaxial cable, connect the VCR’s OUT jack to the TV’s VHF/UHF jack.

3 Using AUDIO and S VIDEO cables, connect the VCR’s AUDIO and S VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.

Rear of TV

AUDIO cable (not supplied)

Note

To watch the pictures input from the S VIDEO input jack, set “Auto YC” to “On” in the (Setup) menu (See below).

Tips

•You can also use the VIDEO 2 IN jacks to connect your VCR.

•If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable.

When connecting both VIDEO OUT and S VIDEO OUT

You can select the jack the TV receives the input signal from on the menu screen.

You can set it for each video input (VIDEO 1 IN and VIDEO 2 IN) separately.

The TV is factory set to receive S VIDEO input signals.

1Press TV/VIDEO repeatedly until the desired video input appears.

2Press MENU.

	3	Press V/v to select (Setup), then press		.
	4	Press V/v to select “Auto YC,” then press		.
	5	To watch the pictures input from the S VIDEO input jack:
		Press V/v to select “On,” then press	.
		To watch the pictures input from the VIDEO input jack:
		Press V/v to select “Off,” then press	.
12	6	Press MENU to exit the menu screen.
12