Installing and Connecting the TV
Basic Connections (Connecting Cable TV or an Antenna)
When connecting an antenna or cables, remove the rear cover of the TV beforehand.
Removing the rear cover1Hold the lower right (or left) corner of the back cover as illustrated below and pull it towards you. Do the same to the remaining left (or right) corner.
2Hold the bottom edge of the cover with both hands as illustrated and lift upwards.
VHF/UHF
Note
It is strongly recommended to connect the antenna using a 75- ohm coaxial cable to get optimum picture quality. A
Use this hookup if:
•You subscribe to a cable TV system that uses scrambled or encoded signals requiring a cable box to view all channels, and
•You do not intend to hook up any other audio or video equipment to your TV.
1 Connect the coaxial connector from your cable service to the cable box’s IN jack.
2 Using the supplied
Cable
Rear of TV
VHF/UHF
Hold the rear cover as illustrated below, fitting the four pegs on the rear cover into the corresponding holes on the TV, then push the rear cover back onto the TV.
INOUT
Cable box
Also, set “Cable” to “On” in the (Channel) menu (See page 21).
Tips
•Your Sony remote control can be programmed to operate your cable box (See “Programming the remote control” on page 34).
•To change channels using the cable box, set your TV to channel 3 or 4 depending on the cable box channel output.
•If you will be controlling all channel selection through your cable box, consider using the Channel Fix feature to set your TV to channel 3 or 4 (See page 22).
8