Connecting the TV

Connecting Optional Equipment

VCR, Cable and Antenna

zThe most common setup is the Cable input into the VCR Antenna IN, the VCR Antenna Out to the VHF/UHF input.

You can connect a variety of optional equipment to your TV. This section provides some of the individual connections you can make. For multiple connections, please refer to the Quick Setup Guide.

This scenario shows a VCR with Cable signals connected through the video inputs and the Antenna connected through the VHF/UHF input. The Cable or VCR signals are selected by the VCR through the video inputs while TV signal is selected by the TV tuner.

To connect the VCR and cable

1Connect the CATV cable to the VCR’s VHF/UHF input jack.

2Connect the supplied 75-ohm coaxial cable from the antenna to the TV’s VHF/UHF input jack.

3Use A/V and S VIDEO cables to connect the VCR’s AUDIO and

S VIDEO output jacks to the TV’s AUDIO and S VIDEO input jacks (VIDEO 1 IN).

4Run the Initial Setup Program, as described in “Setting Up the Channel List” on page 31.

If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable.

TV the Connecting

(Continued)

25