Sony KLV S15G10, KLV S20G10 Programming the Remote Control, Sony Equipment, Programmable Code Number, 1To check if the code works, to be used with this remote control

Watching the TV

Programming the Remote Control

The remote control is preset to operate Sony brand video equipment.

Sony Equipment	Programmable Code Number
VCR/DVD	301	(Sony VCR)

SAT/CABLE	801	(Sony Satellite Receiver)

Follow the steps below to program your TV’s remote control to operate non-

3 Sony video equipment.

The equipment must have infrared (IR) remote capability in order

to be used with this remote control.

Find the three-digit code for your equipment from the “Manufacturer’s Codes” listed on page 35. If more than one code number is listed, try entering from the code listed first.

1Press CODE SET.

2Press the or FUNCTION button you want to program on

	2	the remote control.
	2	the remote control.
		The selected FUNCTION button (VCR/DVD or SAT/CABLE) will
		flash.

3 Enter the three-digit manufacturer’s code number using the --9buttons while the button is lit (approximately 10 seconds).

4 Press button.

When the programming is correct, the selected FUNCTION button will flash twice slowly, and when not, flashes five times quickly.

1To check if the code works

Aim your TV’s remote control at the equipment, and press the VCR/DVD and/or SAT/CABLE (POWER) button that corresponds with the equipment. If the equipment responds, the programming is completed. If not, try the next code listed.

Insert two size AA batteries (supplied) by matching the e and E on the batteries to the diagram inside the remote control’s battery compartment.

If you enter a new code number, the code number you previously entered at that setting is erased.

If no code is input within the above specified time, or an invalid or incorrect code number is input, the remote control automatically goes back to the previous setting.

In some cases, you may not be able to program your remote control to operate other equipment. In such cases, use the equipment’s own remote control.

Dead batteries or removing the batteries may cause the programmable codes to be lost and revert back to factory settings. Reprogramming the codes may be necessary.