Connecting the TV
Setting Up the Channel List
After you finish connecting your TV, you need to run Initial Setup, which automatically sets up available channels. The Initial Setup screen appears when you turn on your TV for the first time after hooking it up. If you do not want to set up the channels at this time, you can do it later by selecting the Auto Program option in the Channel menu (see page 45).
The Auto Program feature does not apply for installations that use a cable box.
The factory default setting for channel selection is Cable On. For antenna connections, run the Auto Program again after selecting Cable Off from the menu.
Using Initial Setup To run Initial Setup the first time you turn on your TV
1Press POWER to turn on the TV. The Initial Setup screen appears.
2Press V or v on the remote control to select the
language. Then press 
.
The message “First please connect cable/antenna” appears.
By default, Auto Program is set to scan cable TV channels.
3Press CH + to start Auto Program.
Auto Program automatically creates a list of receivable channels. When finished, the lowest numbered channel is displayed. When all the receivable channels are stored, the Show/Hide Channels menu appears.
To scan available VHF/UHF antenna channels instead of the cable TV channels
1Press MENU, then go to Channel menu.
2Set Cable to Off.
3Start Auto Program by pressing 
.
To perform Auto Program again, follow the above instructions. Depending on your signal source, be sure to set Cable to On or Off accordingly (see page 45).
The Initial Setup menu will appear each time the TV is turned on until you complete the scanning for the available channels.
TV the Connecting
31