You can program the supplied remote control to operate a cable box or DBS receiver. Follow the procedures below to set the manufacturer’s code number in the remote control.
|
|
| DBS/CABLE (POWER) | |
|
|
| DBS/CABLE |
|
|
|
| (FUNCTION) |
|
DISPLAY* |
|
|
|
|
1 | 2 | 3 |
|
|
4 | 5 | 6 | 0 – 9 buttons | |
7 | 8 | 9 |
|
|
JUMP | 0 |
| ENTER |
|
TV/DBS* |
|
| GUIDE* |
|
|
|
| V/v/B/b/ | * |
MENU*
CH +/–
CODE SET
*The TV/DBS, GUIDE, DISPLAY, V/v/B/b/ , and MENU buttons can be used only with a DBS receiver.
1 Turn off the equipment you want to set up, and press DBS/CABLE (FUNCTION).
FUNCTION
DBS/CABLE
2 Press the CODE SET, DBS/CABLE (FUNCTION), and 0 – 9 buttons to enter the manufacturer’s code number (see the chart on the right column), then press ENTER. For example, to program your remote control to operate a Sony DBS receiver, press CODE SET, DBS/CABLE (FUNCTION), 8, 0, 1, and
ENTER.
FUNCTION |
| ENTER | |
CODE SET DBS/CABLE |
| ||
0 | 1 | ||
8 |
3 Press DBS/CABLE (POWER) to turn on the cable box or DBS receiver.
DBS/CABLE
4 Use the cable box/DBS control buttons to check if the code number works.
For example, to operate a cable box or DBS receiver, you can use the DBS/CABLE (POWER), JUMP, CH
Note
•If the cable box or DBS receiver does not have a certain function, the corresponding button on this remote control will not operate.
To operate the projection TV
Press TV (FUNCTION). Then use the projection TV control buttons to control the projection TV.
For more details on operating the cable box or |
|
DBS receiver |
|
Refer to the operating instructions that come with the |
|
equipment. | EN |
If the remote control doesn’t work
•First, try repeating the setup procedures using the other codes listed for your equipment.
Manufacturer code numbers (cable box)
Manufacturer | Code number |
Hamlin/Regal | 222, 223, 224, 225, 226 |
Jerrold/G. I. | 201, 202, 203, 204, 205, 206, 207, 208, |
| 218 |
Oak | 227, 228, 229 |
Panasonic | 219, 220, 221 |
Pioneer | 214, 215 |
Scientific Atlanta | 209, 210, 211 |
Tocom | 216, 217 |
Zenith | 212, 213 |
|
|
Manufacturer code numbers (DBS receiver)
Manufacturer | Code number | |
Sony | 801 | (preset code for the supplied |
|
| remote control) |
RCA | 802 |
|
Notes
•If more than one code number is listed, try entering them one by one until you come to the correct code for your equipment.
•If you enter a new code number, the code number you previously entered at that setting is erased.
•In some rare cases, your equipment may use a code that is not provided with this remote control and you may not be able to operate your equipment with the supplied remote control. In this case, use the equipment’s own remote control unit.
•Whenever you remove the batteries — to replace them, for example — if too much time is taken, the code numbers may revert to the factory setting and must be reset.
Operations