Sony KP-FX432 Troubleshooting (continued)

Troubleshooting (continued)

Symptom	Possible cause	Solutions	Page
No picture	• The power cord,	• Check the power cord, antenna and	7
	antenna or VCR is not	the VCR connections.
	connected.
	• The projection TV is not	• Press I/1 on the remote.	16
	turned on.	• Press ! on the projection TV to turn	17
No sound
		off the projection TV for about five
		seconds, then turn it on again.
Good picture	• The volume level is	• Press 2 + to increase the volume	17
	too low.	level.
	• The sound is muted.	• Press % to cancel the muting.	17
	• The broadcast signal	• Press A/B until a better sound is	27
	has a transmission	heard.
No sound	problem.
	• The sound of the	• Press or .	22
	right picture is
	selected when TWIN
	pictures are
	displayed.
Dotted lines or	• There is local	• Do not use a hair dryer or other	–
	interference from	equipment near the projection TV.
stripes
	cars, neon signs, hair	• Adjust the antenna direction for	–
	dryers, power
		minimum interference. Contact a
	generators, etc.
		Sony dealer for advice.
Double images or	• Broadcast signals are	• Use a highly directional antenna.	–
	reflected by nearby	• Use the fine tuning (“Fine”) function.
			50
“ghosts”	mountains or
	buildings.
	• The antenna direction	• Adjust the antenna direction. Contact	–
	needs adjustment.	a Sony dealer for advice.
	• Use of a booster is	• Turn off or disconnect the booster if	–
	inappropriate.	it is in use.
No color	• The color level	• Display the “Picture” menu and select	40
	setting is too low.	“Personal” of “Picture Mode”, then adjust
		the “Color” level under “Picture
		Adjustment”.
	• The color system setting	• Display the “Setup” menu and check	47
	is inappropriate.	the color system (“Color System”)
		setting (usually set this to “Auto”).
	• The antenna direction	• Adjust the antenna direction. Contact	–
	needs adjustment.	a Sony dealer for advice.

58Additional Information