Sony KV-28DS60U, KV-28DS65U, KV-32DS60U, KV-32DS65U Additional Information When, Connecting Equipment, Selecting The Output Source For The Scart Socket F

Optional Connections

Using Optional Equipment

Additional Information When

Connecting Equipment

Connecting a VCR

A. Standard connection for strong signal:

To record and playback digital programmes connect your VCR to the F socket using a scart lead (the VCR relies on the TV to convert the digital programmes to video and audio signals suitable for recording, which are then output from the TV through the scart connector).

To record analogue programmes on the VCR, connect your external aerial to the RF input socket on your VCR, then connect the VCR output lead to the upper aerial socket marked on the TV.

B. Alternative connection for weak signal areas:

If poor reception occurs due to weak signals, then the following configuration is recommended (to avoid the possibility of the VCR affecting the TV signal quality):

To record and playback digital programmes connect your VCR to the F socket using a scart lead.

To record analogue programmes on the VCR, connect your external aerial to the upper aerial socket marked on the TV, then connect a lead from the RF input of the VCR to the lower aerial socket marked on the TV.

Note: In this configuration, the TV must be switched on or in standby for the signal to pass through the TV to the VCR.

Front of TV

8mm/Hi8

A B	C	D
	S 3	3 MONO

L/G/S/I R/D/D/D

3

S-VHS/Hi8

Rear of TV

....

G

Connecting Headphones

Plug in your headphones to the A socket on the front of the TV set.

1/ 1 2 S 2 4 S 4

Connecting to External Audio Equipment

Plug in your Hi-Fi equipment to the H sockets on the rear of the TV if you wish to amplify the audio output from the TV.

The output level of signals from the H socket is adjusted by changing the headphone volume. Refer to the ‘Adjusting the Sound’ section of this

manual. 12

	L/G/	..
C	S/I
S	R/D/
	D/D
S
R/D/D/D	L/G/S/I

MODEM

DVD

PlayStation

For Mono Equipment

Connect the phono plug to the L/G/S/I socket on the front of the TV and select the 3 input signal using the instructions on the previous page. Finally, refer to the ‘Adjusting the Sound’ section of this manual and select ‘A’ on the sound menu screen.

Decoder Hi-Fi

VHS

VCR

Selecting The Output Source For The Scart Socket F

1Press the MENU button on the remote control to display the menu on the TV screen.

2Move the OK button DOWN to select the symbol on the menu screen then move RIGHT to enter the ‘VIDEO CONNECTION’ menu screen.

3Move the OK button DOWN to highlight ‘TV Screen’ (input source for the

TV screen) or ‘AV2 Output’ (output source for 2/ s 2) then move RIGHT to confirm.

4Move the OK button DOWN to select the desired source (see below) then press the OK button to confirm:

TV Screen:	TV, AV1, RGB, AV2, YC2, AV3, YC3, AV4, YC4
Output:	TV, AV1, AV2, YC2, AV3, YC3, AV4, YC4

5Press the MENU button to remove the menu from the TV screen.

SCREEN MODE

Screen Mode		[zoom		]
Screen Position		[	0	]
Strobe	[on]
Auto 16:9
Correction	[off]

VIDEO CONNECTION

TV Screen	[TV	- - - - - ]
AV2 Output	[TV	- - - - - ]

TVTV

33