Listening to the radio

Use buttons on the remote for the operation.

1 Press FUNCTION +/– repeatedly to select FM or AM band.

2 Press TUNING MODE repeatedly until “AUTO” lights up in the display.3 Press +/–.

You can also use TUNE +/– on the unit.

Scanning stops automatically when a station is tuned in and “TUNED” lights up in the display. When a FM stereo program is tuned in, “STEREO” lights up in the display.

Note

If “TUNED” does not light up and scanning does not stop, see “To tune in a station with a weak signal” below.

4 Press VOLUME +/– to adjust the volume.To stop automatic scanning

Press x.

To tune in a station with a weak signal

Use buttons on the remote for the operation.

1Press TUNING MODE repeatedly until “AUTO” and “PRESET” disappear from the display.

2Press +/– repeatedly to tune in the station you want.

You can also use TUNE +/– on the unit.

To change the AM tuning interval (Except for European model)

The factory setting for AM tuning interval is 9 kHz (or 10 kHz for some areas). Use the buttons on the unit for the operation.

1Press TUNER/BAND repeatedly to select AM band.

2Press "/1 to turn off the system.

3When demonstration appears, hold down ENTER on CHANNEL B and then press "/1.

The system turn on automatically. “AM 9K STEP” or “AM 10K STEP” appears in the display.

When you change the interval, all the AM preset stations are erased.

Tip

To improve broadcast reception, adjust the supplied antennas, or connect an external antenna.

To reduce static noise on a weak FM stereo station

Press FM MODE on the remote repeatedly until “MONO” lights up in the display.

There will be no stereo effect, but the reception will improve.

20GB