Sony LocationFree Player for PSP 8 Check the settings list, 9 Connect to the Base Station

7 Press the SETUP MODE button on the front (LF-V30/LF-B20/LF-B10) of the Base Station.

With the Base Station turned on, press and hold the button until the SETUP MODE LED starts to blink.

LF-V30

WIRELESS		WIRELESS
NETWORK		NETWORK
NET AV	SETUP	NET AV	SETUP
	SETUP		SETUP
MODE	MODE	MODE	MODE LED
SETUP		SETUP
RESET		RESET

LF-B20/LF-B10

			SETUP MODE/
			NET AV
WIRELESS	SETUP MODE	WIRELESS	SETUP
NETWORK	SETUP MODE	NETWORK	SETUP
SETUP MODE/		SETUP MODE/	MODE/
SETUP MODE		SETUP MODE	MODE/
NET AV		NET AV
			NETAV LED
RESET		RESET

Wait while the PSP® system registers with the Base Station and the network settings required for establishing a connection are completed. This is an automatic process.

Notes

•Depending on the condition of the Base Station and the PSP® system, it may take a few minutes to complete the settings.

•If more than 5 minutes pass from when the SETUP MODE LED starts to blink, the LED will go from blinking to fully lit (LF-B20/LF- B10) or to off (LF-V30) and the registration process ends.

In this case, press the SETUP MODE button on the Base Station again and hold the button down until the SETUP MODE LED starts to blink.

•If a message stating "You must update the base station" is displayed, you must perform a software version update. You can perform the update from the Base Station Settings menu (1 page 25).

8 Check the settings list.

Press the button to finish the settings. A network settings list is displayed.

Note

If a message stating "The wireless channel of the base station is set to the 5 GHz range" is displayed, you must change the settings for the Base Station.

For details, refer to the Operating Instructions supplied with the Base Station.

9 Connect to the Base Station.

Select the wireless access point which you wish to use, and then press the button.

* Screen image simulated.

A connection to the Base Station is established.

Started Getting