if the function controlled by the remote control (see figure 1) is not set correctly the remote control will not function after the connected device is turned on. In this case, switch the function controlled by the remote control to the function in use.
Using the learning remote control data
The learning remote control data created by the LocationFree® Player
MSSONY LF RC_DATA
zTips
•Remote panel skins (available with
•The Add buttons feature within the
Changing the Screen Mode
1 Select 
from the control panel, and then press the 
button.
Each time the 
button is pressed, the Screen Mode will change as follows:
Type | Description |
Zoom | The image is shown at full screen |
| size without changing proportions, |
| while cutting off the top and bottom |
| areas. |
|
|
Full Screen | The image is shown in the full screen |
| size by changing proportions and |
| zooming in horizontally and |
| vertically. |
|
|
Original | The image is shown in the original |
| size. |
|
|
Normal | The image is adjusted to fit the PSP® |
| system’s screen size. |
|
|
Adjusting the Video Rate
Depending on network conditions, you can adjust the video rate for optimal viewing.
Normally, selecting [Automatic] sets the optimal video rate in accordance with available bandwidth.
When selecting a rate manually, a higher rate (a larger number) results in better picture quality but also requires larger bandwidth. Note that insufficient bandwidth may cause the video to stop intermittently.
1 Select 
from the control panel, and then press the 
button.
The screen for selecting a rate is displayed.
2 Using the directional buttons on the PSP® system, select the desired rate, and then press the 
button.
The rate is changed.
Player LocationFree® the on Video or TV Watching
17