Note

The volume can only be increased up to +12.0 dB (for analog recording) or +18.0 dB (for digital recording). Therefore, if the output level of the connected component is low, it may not be possible to set the recording level to maximum.

Recording tips

TIME

 

INPUT REC z MENU/NO

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

EJECT A AMS

YES

MDs to Recording

Checking the remaining recordable time on the MD

Press TIME repeatedly.

While the deck is

The following information

appears

 

 

 

 

Total number of tracks and total

Stopped

recorded time y Total number of

tracks and remaining recordable time on

 

 

the MD1)

 

Track number and recorded time of the

Recording

current track y Track number and

 

remaining recordable time2) on the MD

1)Not shown for premasterd discs.

2)Time shown in the display differs depending on the setting of

REC MODE.

Monitoring the input signal (Input Monitor)

You can monitor the selected input signal even when you are not recording it.

1Press EJECT A to eject the MD.

2Press INPUT repeatedly to select the jacks (connector) where the signal you want to monitor is being input.

3Press REC z.

When INPUT is set to ANALOG

The analog signal input from the ANALOG IN jacks is output to the DIGITAL OUT connector after A/D conversion, and then to the ANALOG OUT jacks and PHONES jack after D/A conversion. “AD – DA” appears in the display during this time.

When INPUT is set to OPT1, OPT2 or COAX

The digital signal input from the DIGITAL IN connector is output to the DIGITAL OUT connector after passing through the sampling rate converter, and then to the ANALOG OUT jacks and PHONES jack after D/A conversion. “ – DA” appears in the display during this time.

GB 18 Adjusting the recording level/Recording tips