MDs to Recording

9Start playing the program source.

Operations you may want to do during recording

To

Press

 

 

Stop recording

x

 

 

Pause recording

X

 

 

Resume recording after

Hor X

pausing

 

 

 

Eject the MD

Aafter stopping recording

 

 

To change the display while recording

Press LEVEL/DISPLAY/CHAR (or DISPLAY) repeatedly to change the display.

Each press of the button changes the display as follows:

MDS-JE640

Track number and recorded time of the current track

r

Level of the input signal (setting value of the recording level)

r

Sampling frequency indication

“FS -- kHz” appears while the analog signal is input.

MDS-JE440

Track number and recorded time of the current track

r

Remaining recordable time1) on the MD

r

Level of the input signal

r

Track name2)

1)Time shown in the display differs depending on the setting of

REC MODE.

2)“No Name” appears when the track has no name.

When you pause recording

The track number increases by one. For example, if you paused recording while recording track 4, the track number will be 5 when you resume recording.

To prevent accidental erasure of the recorded material

To protect an MD recording, slide the record-protect tab in the direction of the arrow (see illustration below) to open the slot. To enable re-recording, close the slot.

Record-protect tab

Slide in the direction of arrow

zYou can play the tracks you have just recorded

Press Himmediately after stopping recording.

The deck starts to play from the first track of the material just recorded.

zYou can play from the first track of the MD after recording

1Press x again after stopping recording.

2Press H.

The deck starts to play from the first track of the MD.

Note

You cannot record over existing material when Shuffle Play (page 27) or Program Play (page 27) has been selected. “Impossible” appears in the display at this time.

14 Recording to an MD