Waking up to music (continued)
4 Press . or > repeatedly to select “DAILY 1 (or 2)”, then press
ENTER.
“ON” appears and the hour digits flash in the display.
1
5 Set the time to start playback.
Press . or > repeatedly to set the hour, then press ENTER.
The minute indication starts flashing.
1
Press . or > repeatedly on the remote to set the minute, then press
ENTER.
The hour indication flashes again.
6 Set the time to stop playback following the above procedure.
7 Press . or > repeatedly until the music source you want appears.
The indications change as follows:
tTUNER y CD PLAY T t TAPE PLAY T
8 Press ENTER.
The type of timer (DAILY 1 or DAILY 2), followed by the start time, stop time and the music source, appears, then the original display appears.
9 Turn off the power.
To check the setting
Press CLOCK/TIMER SELECT and press
.or > repeatedly to select the respective mode (DAILY 1 or DAILY 2), then press ENTER on the remote.
To change the setting, start over from step 1.
To cancel the timer operation
Press CLOCK/TIMER SELECT and press
.or > repeatedly to select “TIMER OFF”, then press ENTER.
Notes
•You cannot activate DAILY 1 and DAILY 2 timer at the same time.
•You cannot set timer if the timer on and off times are the same.
•When you use the Sleep Timer, Daily Timer and Timer recording will not turn on the system until the Sleep Timer turns it off.
•You cannot activate Daily Timer and Timer recording at the same time.
Tip
The power turns on 15 seconds before the preset time.
36
