To tune in a station with a weak signal
Press + or – (TUNING +/– on the remote) repeatedly to tune in the station manually.
To set another station to the existing preset number
Start over from step 1. After step 3, turn SHUTTLE until it clicks to select the preset number you want to store the other station.
You can add a new preset number after the last preset number.
To erase the preset station
1Hold down TUNER MEMORY until a preset number appears in the display.
2Turn SHUTTLE until it clicks to select the preset number you want to erase.
Select “ALL ERASE” when you want to erase all the preset stations.
3Press ENTER. “COMPLETE” appears.
When you erase a preset number, the preset number decreases by one and all preset numbers following the erased one are renumbered.
To change the AM tuning interval
(Except for the European and Middle Eastern models)
The AM tuning interval is factory set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the power. While holding down the ENTER button, turn the power back on. When you change the interval, AM preset stations will be erased. To reset the interval, repeat the same procedure.
Tip
The preset stations are retained for half a day even if you unplug the power cord or if a power failure occurs.
Saving the power in standby mode
(For European and North American models only)
You can lower the power consumption to minimum (Power Saving Mode) and save energy in standby mode.
?/1
(Power)
DISPLAY
,Press DISPLAY repeatedly when the power is off. Every time you press the button, the system switches as follows:
t Demonstration t Clock
Power Saving Mode T
The system is turned on/off by pressing ?/1.
Tips
•?/1 indicator and timer indicator (when the timer is set) light up even in the Power Saving Mode.
•The timer works in the Power Saving Mode.
Note
You cannot set the time in the Power Saving Mode.
To cancel the Power Saving Mode
Press DISPLAY once to show the demonstration, twice to show the clock
display.9
