Tune in the preset radio station (see “Listening to the radio” on page 15).
Press CLOCK/TIMER SET. “DAILY1 SET” appears.
Insert a recordable tape into deck B, then press CD.

Recording a CD by specifying track order

— Program Edit

When programming, make sure the playing times for each side do not exceed the length of one side of the tape.

1

2 Press PLAY MODE repeatedly until “PROGRAM” appears in the display.

3 Press DISC 1–3 to select a CD.

To program all the tracks on a CD at once, proceed to step 5 while “AL” appears in the display.

4 Press . or > repeatedly until the track you want appears in the display.

 

Disc tray

Track

Total playing time

 

 

number

number

(including selected track)

PROGRAM

 

 

 

 

 

MUSIC

 

 

MOVIE

 

1

2

3

 

A

B

 

 

 

 

GAME

 

 

TOOL

 

5 Press ENTER.

The track(s) is (are) programmed. The program step number appears, followed by the total playing time.

6 To program additional tracks, repeat steps 3 to 5.

Skip step 3 to select tracks from the same disc.

7 Press CD SYNC HI-DUB.

Deck B stands by for recording. To reduce the hiss noise in low-level high-frequency signals, press DOLBY NR so that “DOLBY NR” appears in the display. The REC PAUSE/START button flashes.

8 Press DIRECTION repeatedly to select

gto record on one side.

Select j (or RELAY) to record on both sides.

9 Press REC PAUSE/START.

Recording starts.

To cancel Program Edit

Press PLAY MODE repeatedly until “1 DISC” or “ALL DISCS” appears in the display.

Tip

To check the required tape length for recording a CD, press EDIT after you have inserted a CD and pressed CD. The required tape length for the currently selected CD appears, followed by the total playing time for side A and side B (Tape Select Edit).

Note

You cannot use Tape Select Edit for discs containing over 20 tracks.

Timer-recording radio

programs

To timer-record, you must set the clock (see “Setting the time” on page 11) and preset the radio stations (see “Presetting radio stations” on page 15) beforehand.

1

2

3 Press . or > repeatedly to select “REC SET”, then press ENTER.

“ON” appears and the hour indication flashes.

4 Set the time to start recording.

Press . or > repeatedly to set the hour, then press ENTER.

The minute indication flashes.

Press . or > repeatedly to set the minutes, then press ENTER.

The hour indication flashes again.

continued

Tape

19