Tuner
Presetting radio stations
You can preset 20 stations for FM and 10 stations for AM.
1
2 Press and hold m or M until the frequency indication starts to change, then release.
Scanning stops when the system tunes in a station. “TUNED” and “STEREO” (for a stereo program) appear.
TUNED
STEREO
MHz
3 Press TUNER MEMORY.
A preset number appears in the display. The stations are stored from preset number 1.
Preset number
4
5 Repeat steps 1 to 4 to store other stations.
To tune in a station with a weak signal
Press m or M repeatedly to tune in the station manually.
To set another station to an existing preset number
Start over from step 1. After step 3, press . or > repeatedly to select the preset number where you want to store a new station, then proceed to step 4.
Tips
•Pressing TUNER/BAND while the power is off automatically turns the power on.
•You can use the digipad instead of ./>.
•The preset stations are retained for half a day even if you unplug the power cord or if a power failure occurs.
To change the AM tuning interval (Except for European and Middle Eastern models)
The AM tuning interval is factory set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the power. While holding down the ENTER button, turn the power back on. When you change the interval, AM preset stations will be erased. To reset the interval,
repeat the same procedure. | Tuner |
|
Listening to the radio
–– Preset Tuning
Preset radio stations in the tuner’s memory first (see “Presetting radio stations”).
1 Press TUNER/BAND repeatedly to select FM or AM.
2 Press . or > repeatedly to tune in the preset station you want.
Preset number | Frequency |
MHz
To | Do this |
Turn off the radio | Press ?/1. |
|
|
To listen to non-preset radio stations
In step 2, press m or M repeatedly (Manual Tuning) or press and hold m or M (Automatic Tuning).
Tips
•Pressing TUNER/BAND while the power is off automatically turns the power on.
•You can use the digipad instead of ./>.
•When an FM program is noisy, press FM MODE so that “MONO” appears in the display. There will be no stereo effect, but the reception will improve.
•To improve broadcast reception, reorient the antennas.
15