Waking up to music
—Daily Timer
You can wake up to music at a preset time every day. Make sure you have set the clock (see “Setting the clock” on page 8).
1 Prepare the music source you want to play.
•CD: Load a CD. To start from a specific track, make a program (see “Programming the CD tracks” on page 10).
•Tape: Load a tape with the side you want to play facing forward.
•Radio: Tune in the preset station you want (see “Listening to the radio” on page 11).
2 Adjust the volume.
3 Press CLOCK/TIMER SET on the remote.
“DAILY1 SET” appears.
4 Press V or v repeatedly to select “DAILY1 SET (or DAILY2 SET)”, then press ENTER.
“ON” appears and the hour digits flash in the display.
5 Set the time to start playback.
Press V or v repeatedly to set the hour, then press ENTER.
The minute indication flashes.
Press V or v repeatedly on the remote to set the minute, then press ENTER.
The hour indication flashes again.
6 Set the time to stop playback following step 5 above.
7 Press V or v repeatedly until the music source you want appears.
The indications change as follows:
tTUNER y CD PLAY T t TAPE PLAY T
8 Press ENTER.
The type of timer (“DAILY1” or
“DAILY2”), followed by the start time, stop time and the music source appears, then the original display appears.
9 Turn off the power.
To | Do this |
Check the setting | Press CLOCK/TIMER |
| SELECT on the remote and |
| press V or v repeatedly to |
| select the respective mode |
| (“DAILY1” or “DAILY2”), |
| then press ENTER. |
Change the setting | Start from step 1. |
|
|
Cancel the timer | Press CLOCK/TIMER |
operation | SELECT on the remote and |
| press V or v repeatedly to |
| select “TIMER OFF”, then |
| press ENTER. |
Tip
The power turns on 15 seconds before the preset time.
Note
If the power is on at the preset time, the Daily Timer does not work.
