Troubleshooting

If you experience any of the following difficulties while using the receiver, use this troubleshooting guide to help you remedy the problem.

There is no sound, no matter which component is selected, or only a very low-level sound is heard.

•Check that the speakers and components are connected correctly and securely.

•Check that both the receiver and all components are turned on.

•Check that MASTER VOLUME is not set to “VOL MIN”.

•Check that the headphone is not connected.

•Press MUTING to cancel the muting function.

•Check that you have selected the correct component with the input buttons.

•The protective device on the receiver has been activated. Turn off the receiver, eliminate the short-circuit problem, and turn on the power again.

There is no sound from a specific component.

•Check that the component is connected correctly to the audio input jacks for that component.

•Check that the cord(s) used for the connection is (are) fully inserted into the jacks on both the receiver and the component.

•Check that you have selected the correct component on the receiver.

There is no sound from one of the front speakers.

•Connect a pair of headphones to the PHONES jack to verify that sound is output from the headphones. If only one channel is output from the headphones, the component may not be connected to the receiver correctly. Check that all the cords are fully inserted into the jacks on both the receiver and the component. If both channels are output from the headphones, the front speaker may not be connected to the receiver correctly. Check the connection of the front speaker which is not outputting any sound.

•Make sure you have connected to both the L and R jacks of an analog component, and not only to either the L or R jack. Use an audio cord (not supplied).

There is no sound from analog 2 channel sources.

•Check that the INPUT MODE is not set to “COAX IN” or “OPT IN” for the selected input (page 52).

There is no sound from digital sources (from COAXIAL or OPTICAL input jack).

•Check that the INPUT MODE is not set to “ANALOG” (page 52). Check that the INPUT MODE is not set to “COAX IN” for the sources from the OPTICAL input jack, or to “OPT IN” for the sources from the COAXIAL input jack.

The left and right sounds are unbalanced or reversed.

•Check that the speakers and components are connected correctly and securely.

•Adjust the balance parameters using the LEVEL menu.

58GB