16 Projecting an Image
2Press the ENTER key.
The cursor appears.
3You can adjust the deflection of the
side, using V/v/B/b.
You can adjust the center point of
deflection using B/b. For the range of
deflection, use V/v. You can adjust the
top/bottom independently.
The cursor will disappear if the
deflection range limit is reached.
Setting the blending function to
project from multiple projectors
1Install the projectors.
Input a pattern, etc., to adjust the
projected positions from multiple
projectors.
Set a different ID mode for each
projector (page25 ).
2Enable the Edge Blending function.
Display the main menu to set “Edge
Blending” to “On” in the Installation
menu.
3Set the position of blending.
Choose the position (top/bottom/left/
right) for blending.
4Assign the blending width.
Set the blending width according to the
overlapping range for the source signal.
5Adjust using “Zone Black Level Adj.”
Adjust using this cursor
Example of cursor display:
Adjust in all directions
Leftward, rightward or
downward adjustment only
Assign the position and width here.